Can A Deep Scratched Plastic Bumper Be Repaired

Got a bumper scuff or scratch? While not as astringent as a bumper crevice or dent, a trip to an auto body repair store can still cost an average of $560, and they will probably need to keep your car for a few days. Why not fix it yourself? In this article we are going to evidence you how to repair a scratched urethane plastic or fiberglass bumper cover on your own, in a fraction of the time, at a fraction of the cost.

What yous demand:

• Factory-matched paint in a spray can.
• Automotive spray primer.
• Automotive spray clear coat.
• Some sheets of fibroid and fine sandpaper.
• Scuff pad.
• Cleaning towel.
• Wax and grease remover.
• Scratch-filling putty.

---

Step 1. Apply Masking Tape

Apply masking tape to adjacent panels and plastic trim that could exist accidentally sprayed by bumper pigment.

---

Step 2. Sand Bumper

Wrap a canvas of coarse sandpaper effectually your scuff pad, and sand the bumper with house pressure until yous have smoothed the scratches out.

---

Footstep 3. Clean Panel

In one case y'all are done sanding wipe down the panel with your cleaning towel, then make clean the entire console with wax and grease-remover.

---

Step iv. Fill up Scratches

Now if y'all observe whatever scratches that will not sand out, fill them in with a thin layer of scratch-filling putty.

Wait five minutes for it to harden, and then re-sand over the putty using corse sandpaper with firm pressure.

You might demand to echo this pace a second fourth dimension in club to get everything smoothed out.

---

Stride five. Scuff Repair Expanse

Take your scuff pad and scuff at to the lowest degree ten inches all around the repair area.

This is very important because it will help ensure that your paint will permanently stick to your bumper and be more durable over time.

---

Stride six. Prime Bumper

Encompass whatsoever areas that might be hit with unwanted overspray with newspaper or butcher paper.

Shake the primer can for virtually sixty seconds, and employ a thin layer of primer.

Wait two minutes, so apply a heavier layer of primer until yous have covered whatever blank black plastic areas exposed past sanding.

---

Step vii. Paint Bumper

Using the fine-grit sandpaper, sand the primer with light pressure until information technology feels smoothen.

Shake the jar of pigment for about thirty seconds, and then apply multiple coats of paint, about 10-12 inches away.

If y'all encounter any bumps, cloudiness, or "cat" scratches, only await five minutes, sand again until smooth, and effort again.

If you lot have a silver or gilt car and you notice any stripes, follow up with some vertical passes.

---

Step eight. Clearcoat Layer

Once you are done painting, wait at least five minutes before applying a light layer of clearcoat.

Look ii minutes before slowly use a heavier layer, overlapping each pass by about l%.

Wait 10 minutes, remove the tape and newspaper, and you are washed. You lot can wash or wax; it is permanent.

Nosotros'll make it easier for you.

Fix bumper scrapes yourself, in simply 45 minutes, with BumperWizard.

Source: https://scratchwizard.net/blog/how-to-repair-your-scratched-plastic-bumper/#:~:text=Fill%20Scratches,corse%20sandpaper%20with%20firm%20pressure.

Posted by: yatesthfulted.blogspot.com

Share this post